Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.9 CRANKSHAFT ASSEMBLY 12. Measure the crown of the main journals and the connecting-rod journals as listed in Table 1-13. See Figure 1-50. Figure 1-50 Measuring the Crown of the Journal 13. Regrind the main journals. After grinding, see Figure 1-48 for dimensions. [a] Check the outside diameter of each main journal. [b] Check the width of the center main journal. [c] Check the width of the remaining main journals. [d] Check the fillet radius of each main journal. [e] Check the crown of each main journal. [f] Check each main journal for out-of-round. 14. Regrind the connecting-rod journals. After grinding, check the following dimensions.

[a] Check the outside diameter of each connecting-rod journal. [b] Check the width of the each connecting-rod journal. [c] Check the fillet radius of each connecting-rod journal. [d] Check the crown of each connecting-rod journal. [e] Check each connecting-rod journal for out-of-round. 15. Install the crankshaft. Refer to section 1.9.2. [a] When the main bearing caps have been installed, measure the radial play (radial runout) of the crankshaft. Refer to section 1.9.2.2. All information subject to change without notice. 1-70 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION