Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.9 CRANKSHAFT ASSEMBLY 5. Lubricate the main bearing cap bolts with a light coating of clean engine oil. Install them on the main bearing caps. See Figure 1-54. Refer to section 1.9.2 for instructions and tightening torques. 1. Cylinder Block 3. Bearing-Cap Bolt 2. Main Bearing Cap 4. Crankshaft Gear Figure 1-54 Installing the Main Bearing Caps 6. Using a dial gauge and quick-release calipers, measure the inside diameter of each of the main bearings. See Figure 1-55. [a] Measure vertically from the top to the bottom of the bore. (see Figure 1-55, A.) [b] Measure 30 degrees counterclockwise from the separation point of the bearing shells.

(see Figure 1-55, B.) All information subject to change without notice. 1-74 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION