MBE 4000 SERVICE MANUAL [c] Measure 30 degrees clockwise from the separation point of the bearing shells. (see Figure 1-55, C.) 1. Bearing Cap Bolts 3. Main Bearing Shell 2. Main Bearing Cap 4. Crankcase Race Figure 1-55 Measuring the Inside Diameter of the Main Bearing Shells 7. If any one of the readings is not within tolerances listed in Table 1-17, then replace the main bearing shells as applicable. Table 1-17 Bearing Shell and Bearing Journal Diameter NOTE: New bearing shells are supplied ready for installation. Do not machine them or remove any material from them. Refer to section 1.9.2. All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-75 Size: mm (in.) Main Bearing Inside Diameter Main Journal Outside Diameter Standard 104.060-104.106 (4.0968-4.0987) 103.980-104.000 (4.0937-4.0945) Undersize - 0.10 (0.004) 103.960-104.006 (4.0929-4.0947) 103.880-103.900 (4.0898-4.0905) Undersize - 0.25 (0.010) 103.810-103.856 (4.0870-4.0888) 103.730-103.750 (4.0839-4.0846) Undersize - 0.50 (0.020) 103.560-103.606 (4.0772-4.0790) 103.480-103.500 (4.0740-4.0748) Undersize - 0.75 (0.030) 103.310-103.356 (4.0673-4.0691) 103.230-103.250 (4.0642-4.0650) Undersize - 1.00 (0.040) 103.060-103.106 (4.0575-4.0593) 102.980-103.000 (4.0543-4.0551)