1.9 CRANKSHAFT ASSEMBLY 8. Remove the bearing caps. NOTE: If the bolts are going to be used again, check their length. 9. Using a micrometer, measure the outside diameter of the main journals. See Figure 1-56. 1. Micrometer 2. Main Journal Figure 1-56 Measuring the Outside Diameter of the Main Journals NOTE: To obtain a correct value for crankshaft radial play, the diameters of each bearing bore and its corresponding journal must belong to the same repair stage (both must be "Standard," "Undersize - 0.004 inch," etc.). 10.
Calculate the radial play (up-and-down movement) of the main bearings on the crankshaft journals.If the radial play is less than 0.060 mm (0.0024 inch), or more than 0.126 mm (0.0050 inch) as listed in Table 1-18, then replace the crankshaft. Table 1-18 Crankshaft Radial Play [a] For the main bearing shell, note the inside diameter of the bearing shell. Example: D s = 4.0875 inches. All information subject to change without notice. 1-76 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description mm (inch) Main Journal Radial Play 0.060-0.126 (0.0024-0.0050)