Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.9 CRANKSHAFT ASSEMBLY [b] Move the crankshaft all the way forward by prying on one of the bearing caps, then reset the dial gauge to "0" (zero). [c] Move the crankshaft all the way aft. Note the end play on the dial gauge. [d] If the end play does not correspond to the calculated amount (in the example above: 0.0090 inch), replace the crankshaft. 7. Install the engine. 1.9.3 Crankshaft Gear Replacement Replace the crankshaft gear as follows: 1. Remove the engine from the vehicle. 2. Remove the flywheel housing. Refer to section 1.16.1. 3. Rotate the crankshaft until the marked gear tooth on the crankshaft gear is aligned between the two similarly marked teeth on the camshaft gear. 4.

Pull the crankshaft gear off the end of the crankshaft. If necessary, use a plastic hammer to loosen the gear. See Figure 1-60. 1. Crankshaft 3. Crankshaft Gear 2. Guide Pin Figure 1-60 Removing the Crankshaft Gear 5. Remove the crankshaft from the engine. Refer to section 1.9.1. All information subject to change without notice. 1-80 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION