MBE 4000 SERVICE MANUAL [c] From the value for the journal width, subtract the value for the bearing shell width. This result is the end play. Example: W m s = 0.0090 inch. NOTE: In the above example, both measurements belonged to repair stage "Standard." If necessary, listed in Table 1-20are the correct repair stages for each measurement. Table 1-20 Bearing Shell and Bearing Journal Width 5. Install the crankshaft. Refer to section 1.9.2. 6. Using a dial gauge and holder, measure the end play of the crankshaft. Measure at the front end of the crankshaft, with the crankshaft fully installed and all the bearing caps tightened to the correct torque. See Figure 1-59. 1. Dial Gauge 3.
Crankshaft 2. Dial Gauge Holder 4. Screwdriver Figure 1-59 Measuring the End Play of the Crankshaft [a] Set up a dial gauge and a dial gauge holder on the front end of the crankshaft. Set the dial gauge to 5 mm (0.2 inch) preload. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-79 Size: mm (in.) Center Bearing Shell Width Center Bearing Journal Width Standard 45.74-45.81 (1.801-1.804) 46.000-46.062 (1.8110-1.8135) Undersize - 0.020 (0.50) 46.24-46.31 (1.820-1.823) 46.500-46.562 (1.8307-1.8331) Undersize - 1.00 (0.040) 46.74-46.81 (1.840-1.843) 47.000-47.062 (1.8504-1.8528)