Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL FALLING FLYWHEEL To avoid injury from a falling flywheel when removing the last bolt, hold the flywheel against the crankshaft by hand to prevent it from slipping off the crankshaft. The flywheel is not doweled to the crankshaft. FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. 7. Remove the remaining eight flywheel bolts. 8. Remove the engine cranking tool (J 46167 or 407 589 00 63 00). Refer to section 1.15.1. 9. Remove the flywheel, leaving the guide studs (904 589 02 63 00)in place. See Figure 1-65. [a] On opposite sides of the bolt circle, screw a bolt into each of two threaded clutch bolt holes.

[b] Using the two bolts as handles, dislodge the flywheel from the crankshaft flange and remove it from the flywheel housing. [c] After removing the flywheel, remove the bolts from the clutch bolt holes. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-89