Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.12 FLYWHEEL 10. Inspect the flywheel bolts. Replace the bolts if any of the shanks are stretched beyond the maximum length of 77.0 mm (3.03 in.). See Figure 1-66. 1. Shank Figure 1-66 Measuring the Flywheel Bolts 11. Thoroughly clean the flywheel and check the clutch surface for cracks, burned spots, or scoring. If the damage exceeds the maximum depth of stock, replace the flywheel. Refer to section 1.12.3.2. 12. Inspect the flywheel flange for signs of wear or traces of hollowing caused by the radial seal. 13. Inspect the flywheel ring gear for damaged teeth or signs of wear. Replace the ring gear if necessary. Refer to section 1.13.1.

1.12.2 Flywheel Installation Install the flywheel as follows: 1. Grease the ring gear with a suitable heavy-duty grease. All information subject to change without notice. 1-90 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION