MBE 4000 SERVICE MANUAL FALLING COMPONENT To avoid injury from a falling component, ensure a proper lifting device is used. 2. Install the flywheel over the guide studs (904 589 02 63 00). Align the dowel on the crankshaft with the guide hole in the flywheel. Align the dowel on the crankshaft with the guide hole in the flywheel (arrow). See Figure 1-67. 3. Install the engine cranking tool (J 46167 or 407 589 00 63 00) in the flywheel housing and secure with two bolts. Insert the pin and make sure the tool is blocked. Refer to section 1.15.2. Figure 1-67 Flywheel Alignment Mark NOTE: Verify the alignment of the crankshaft dowel with the guide hole in the flywheel. 4.
With a light coating of engine oil, lubricate the threads of the ten multipoint socket-head flywheel bolts. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-91