Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.12 FLYWHEEL 5. Tighten the eight bolts in two stages. In each stage, use an alternate sequence to tighten the bolts, as listed in Table 1-21. Table 1-21 Tightening Stages, Flywheel Mounting Bolts [a] Install eight bolts to hold the flywheel in position. [b] Remove the two guide studs (904 589 02 63 00) and install the two remaining bolts in their place. [c] Tighten the bolts, in an alternate tightening sequence, 200 N·m (147.5 lb·ft). [d] Using the same tightening sequence, turn the flywheel bolts 90 degrees. 6. Remove the engine cranking tool (J 46167 or 407 589 00 63 00). Install the inspection cover on the flywheel housing with two bolts. Tighten the bolts 25 N·m (18 lb·ft). 7.

Install the crank angle position sensor into the flywheel housing. Refer to section 2.6.3. 8. Install the clutch on the flywheel. 9. Install the transmission. 1.12.3 Flywheel Inspection Perform the following procedures for inspecting the flywheel. 1.12.3.1 Flywheel Inspection Inspect the flywheel as follows: 1. Remove the flywheel. Refer to section 1.12.1. 2. Thoroughly clean the flywheel and check it for cracks, scoring, burned areas, or rough spots. All information subject to change without notice. 1-92 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Max.

Shaft Length, mm (in.) Tightening Stage Torque Value, N·m (lb·ft) 77.0 mm (3.03 in) Stage 1 200 N·m (147.5 lb·ft) 77.0 mm (3.03 in) Stage 2 90 degrees