Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 3. Using an accurate straightedge and a feeler gauge, check the friction (clutch) surface for evenness. See Figure 1-68. If the surface has areas that are too high or too low, replace the flywheel. 1. Straightedge 2. Friction Surface Figure 1-68 Checking the Friction Surface for Evenness 4. Check the bearing surface and the threaded holes for wear and damage. 1.12.3.2 Flywheel Machining Machine the flywheel as follows: NOTE: Before beginning any machining work on the flywheel, check it to see if machining is possible. If the scores or cracks are deeper than 1 mm (0.04 inch), replace the flywheel.

If the width of the flywheel between the friction surface and the mounting flange is less than 60 mm (2.4 inches), replace the flywheel. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-93