Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.12 FLYWHEEL PERSONAL INJURY To avoid injury while performing the test or procedure, wear adequate eye, face protection, and heat-resistant gloves. 1. Machine the flywheel friction surface, if required, to the specifications listed in Table 1-22. See Figure 1-69. The surface finish (peak-to-valley height) after machining should be 0.016 mm (0.0006 inch). A rougher surface finish will cause rapid clutch lining wear, while a smoother finish could cause difficulties in clutch disengagement. See Figure 1-70for the locations on the flywheel to coordinate with the specifications in the table. Figure 1-69 Machining the Flywheel Friction Surface All information subject to change without notice.

1-94 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION