Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL Table 1-22 Flywheel Specifications 1. Flywheel 2. Ring Gear Figure 1-70 Flywheel Cross Section After machining, the friction surface must not have any cavities or chatter marks. 2. Check the radial and lateral deviation from true of the flywheel. The deviation from true must not exceed 0.2 mm (0.008 inch). 3. Install the flywheel. Refer to section 1.12.2. All information subject to change without notice.

6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-95 Description Specification in mm (inches) Flywheel Outside Diameter 486.60-487.40 (19.157-19.189) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 (17.0256-17.0332) Flywheel Diameter at Crankshaft Flange 114.980-115.015 (4.5268-4.5281) Flywheel Diameter for Mounting Clutch 475.000-475.063 (18.7008-18.7032) Flywheel Minimum Width Between Friction Surface and Mounting Flange After Machining 60 (2.4) Flywheel Maximum Overall Width 70 (2.8) Peak-to-Valley Height (R z) of Clutch Friction Surface 0.016 (0.0006) Flywheel Permissible Deviation From True (radial and lateral) 0.2 (0.008)