1.15 ENGINE CRANKING TOOL 1.15 ENGINE CRANKING TOOL A special tool is required for this procedure: Engine Cranking Tool (J 46167 or 407 589 00 63 00). The engine cranking tool (J 46167 or 407 589 00 63 00) is used for two separate functions: blocking and cranking. With the pin inserted, the tool blocks the flywheel ring gear to prevent rotation during removal and installation of the flywheel. Without the pin, the tool can be used with a wrench to turn the flywheel and crankshaft manually. NOTE: The first time an engine cranking tool is installed on the engine to turn the flywheel, the teeth on the rotating gear may rub on the flywheel housing.
This does not cause a problem and should not occur the next time the tool is used. 1.15.1 Engine Cranking Tool Installation Install the engine cranking tool (J 46167 or 407 589 00 63 00) as follows: 1. Remove the two bolts holding the inspection cover to the flywheel housing. See Figure 1-77. 1. Inspection Cover Figure 1-77 Engine Cranking Tool Installation 2. Remove the pin from the engine cranking tool (J 46167 or 407 589 00 63 00). All information subject to change without notice. 1-102 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION