Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 3. Install the tool in the flywheel housing and secure with two bolts of sufficient length. NOTE: The inspection cover bolts are not long enough to install the engine cranking tool. Longer ones will be needed. 4. As needed, insert the pin to lock the tool and block movement of the flywheel ring gear. 1.15.2 Engine Cranking Tool Removal Remove the engine cranking tool (J 46167 or 407 589 00 63 00) as follows: 1. Remove the two bolts and the cranking tool from the flywheel housing. It is not necessary to remove the pin. 2. Install the inspection cover on the flywheel housing with the two bolts. Tighten the bolts 25 N·m (18 lb·ft). NOTICE:

The engine cranking tool must be removed from the timing case before starting the engine. Failure to do so could damage the flywheel ring gear. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-103