MBE 4000 SERVICE MANUAL 8. Remove the connecting rod stretch bolts and bearing cap. See Figure 1-82. Figure 1-82 Removing the Bearing Caps NOTE: If the bearing shell halves are removed from the rods and caps, be sure to mark them so they can be matched for installation. 9. Remove the bearing shell halves from the bearing cap and connecting rod. 10. Push the piston and connecting rod out of the cylinder, and remove them both from the cylinder block. 11. Secure the connecting rod in a vise with protective jaws. NOTICE: Be sure the vise jaws are adequately lined to prevent the rod surface from being nicked or marred in any way. Such surface damage could lead to later rod cracking or breaking.
12. Remove the piston rings from the piston. Refer to section 1.17.3. 13. Remove the wrist-pin snap rings. Push the wrist pin out and remove the piston from the connecting rod. 1.17.2 Piston Installation Install the piston assembly as follows: All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-109