1.17 PISTON, PISTON RING, AND CONNECTING ROD NOTICE: The half of the bearing shell installed in the connecting rod (rod half) has a specially-treated friction surface that allows it to bear higher loads. It cannot be interchanged (swapped) with the other half of the bearing shell installed in the bearing cap (cap half). 6. Install the rod half of the bearing shell in the connecting rod, as marked on removal. See Figure 1-85. 1. Connecting Rod 3. Bearing Cap 2. Bearing Shells Figure 1-85 Installing the Bearing Shells [a] Be sure that the locking lug in the bearing shell is fully seated in the groove of the rod. [b] Lubricate the bearing surface with a light coating of clean engine oil. 7.
Lubricate the cylinder liners with a light coating of clean engine oil. All information subject to change without notice. 1-112 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION