MBE 4000 SERVICE MANUAL 3. Install the piston rings on the piston. See Figure 1-84. Refer to section 1.17.3. 1. Piston Figure 1-84 Ring Gaps Offset 120 Degrees [a] Lubricate the piston with a light coating of clean engine oil. [b] Install each piston ring in the appropriate groove on the piston. 4. Offset the ring gaps alternately by 120 degrees. 5. Position a ring compressor loosely over the piston. Tighten the ring compressor on the piston. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-111