MBE 4000 SERVICE MANUAL 1. Piston 2. Ring Pliers Figure 1-90 Removing the Piston Rings 3. Clean all the carbon from the ring grooves. Be sure the grooves are not damaged, and that there are no burrs or combustion residue in the grooves. 4. Before installing the new rings, check the end gap. The correct end-gap measurements are listed in Table 1-26. Table 1-26 Piston Ring End-Gap Dimensions NOTE: Check the end gap of the upper two piston rings first. The garter spring must be removed from the third (lowest) piston ring before you can measure its end gap. All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-117 Ring Designation Groove Gap When New, mm (inch) Maximum End Gap, mm (inch) Keystone I 0.45 to 0.60 (0.018 to 0.024) 1.0 (.039) Taper-Faced with Internal Angle II 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039) Double-Chamfered Oil Control with Garter Spring III 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039)