Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.17 PISTON, PISTON RING, AND CONNECTING ROD 3. Measure the inside diameter of the bushing in the small bore of the connecting rod. Use a quick-release caliper (internal measurement, 40 to 60 mm), with a dial gauge and holder. If the value exceeds 52.07 mm (2.050 inches), replace the connecting rod. 1. Dial Gauge 5. Bearing Shell (2 halves) 2. Dial Gauge Holder 6. Bearing Cap 3. Bushing 7. Stretch Bolt (2 qty.) 4. Connecting Rod Figure 1-97 Measuring Inside Diameters in the Connecting Rod NOTE: Checking the connecting rod for a twisted or bent condition in the next step requires machine shop equipment such as a caliper gauge with a round scale.

All information subject to change without notice. 1-124 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION