Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.18 EGR PISTON, PISTON RING, AND CONNECTING ROD 2. Push the piston and connecting rod assembly out of the cylinder liner. 3. Follow remaining steps for non-EGR engine piston removal. Refer to section 1.17.1. 1.18.2 Piston Installation for EGR Engine Perform the following steps to install the piston in an EGR engine: NOTICE: The carbon scraper ring has a smaller internal diameter than the piston skirt diameter; therefore, the piston installation and removal must be carried out with the carbon scraper ring uninstalled or removed. NOTE: Piston installation in the EGR engine is performed with the engine facing upright – not turned on it's side. 1. Install J tool (J 47110) to the cylinder block.

See Figure 1-105. 1. Piston Figure 1-105 Installation of Piston NOTE: There are NO arrows on the top of the EGR piston to direct the installation. The piston can be installed in any direction and it will be correct. All information subject to change without notice. 1-136 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION