Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 1.18 EGR PISTON, PISTON RING, AND CONNECTING ROD The difference from the non-EGR engine cylinder liner to the EGR engine, is a groove on the top part of the cylinder liner, which houses the carbon scraper ring. The EGR engine uses a new tool for piston installation; however, all other procedures are the same for the EGR and non-EGR engine. 1.18.1 Piston Removal for EGR Engine Perform the following steps to remove the piston from an EGR engine: NOTICE: The carbon scraper ring has a smaller internal diameter than the piston skirt diameter; therefore, the piston installation and removal must be carried out with the carbon scraper ring removed. NOTE:

Piston removal in the EGR engine is performed with the engine facing upright not turned on it's side. 1. Remove the carbon scraper ring from the cylinder liner groove. 1. Cylinder Liner 3. Installed Piston 2. Carbon Scraper Ring 4. Installed Carbon Scraper Ring Figure 1-104 Removing Carbon Scraper Ring All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-135