Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.17 PISTON, PISTON RING, AND CONNECTING ROD 3. Measure the inside diameter of the bushing bore in the small bore of the connecting rod. If the measurement exceeds 57.019 mm (2.2448 in.), replace the connecting rod. Refer to section 1.17.3.2. NOTE: The inside diameter of the bushing bore and the outside diameter of the bushing must conform to the specifications listed in Table 1-33. This is necessary to obtain the required interference fit. Table 1-33 Bushing Specifications 4. Measure the outside diameter of the bushing. If the measurement exceeds 57.100 mm (2.2480 in.), replace the bushing. 5. Measure the bushing bore in the connecting rod for deformation.

If the bushing bore is out-or-round by more than 0.01 mm (0.0004 in.), replace the connecting rod. 6. Rest the connecting rod on a flat surface. Using an appropriate drift, install the bushing in the connecting rod. 7. Measure the inside diameter of the bushing. If the measurement is shorter than 52.05 mm (2.049 in.), machine the inside contact surface of the bushing until the measurement is correct. All information subject to change without notice. 1-134 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Dimensions:

mm (in.) Inside Diameter of Bushing 52.05-52.07 (2.049-2.050) Outside Diameter of Bushing 57.080-57.100 (2.2472-2.2480) Inside Diameter of Bushing Bore 57.000-57.019 (2.2441-2.2448) Bushing Interference Fit 0.061-0.100 (0.0024-0.0039) Maximum Permissible Out-of-Round in Bushing Bore 0.01 (0.0004)