1.19 VALVES 5. Check the valve lift on the intake valves. See Figure 1-107. Listed in Table 1-34 are the specifications. 1. Dial Gauge 4. Pushrod 2. Gauge Holder 5. Intake Valve 3. Intake Rocker Arm Figure 1-107 Checking Valve Lift, Intake Valves Table 1-34 Valve Lift Specifications [a] Mount a dial gauge and a gauge holder on the valve bridge. Mount the dial gauge with a preload of approximately 15 mm (0.60 inch) to provide adequate travel for checking the intake valve lift. [b] Set the scale on the dial gauge to "0" (zero). All information subject to change without notice.
1-140 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Specification Specified Dial Gauge Preload for Checking Valve Lift 15 mm (0.60 in) Valve Lift with Intake Valves Completely Open 11.546 mm (at least 0.4546 in) Valve Lift with Exhaust Valves Completely Open 11.963 mm (at least 0.4710 in) Inspection Cover Bolt Torque 25 N·m (18 lb·ft)