Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.19 VALVES 4. Using the cranking tool, turn the crankshaft until cylinder #1 is at the ignition TDC position (all valves are closed) and cylinder #6 is at the valve overlap position (all valves are open). NOTE: When the piston in cylinder #1 or #6 is at ignition TDC, there will be a small bevelled alignment mark visible through the inspection hole. See Figure 1-114. Figure 1-114 Flywheel Alignment Mark 5. Check the valves in the "Ignition TDC" row listed in Table 1-37, and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." * I= Intake Valve and E= Exhaust Valve Table 1-37 Valve Adjustment (Method Two) 6.

Using the cranking tool, turn the crankshaft until cylinder #6 is at the ignition TDC position (all valves are closed) and cylinder #1 is at the valve overlap position (all valves are open). All information subject to change without notice. 1-148 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Engine Cylinder #1 Crankshaft Position Cylinder Valves/Types Cylinder *Valves/Type Cylinder s*Valves/Types Cylinder *Valves/Type Cylinder s*Valves/Types Cylinder *Valves/Types 1 2 3 4 5 6 MBE 4000 Ignition TDC I/E I E I E — MBE 4000 Valve Overlap — E I E I I/E