Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 7. Using the same procedure, check the valves in the "Valve Overlap" row listed in Table 1-37 and adjust them (if necessary), using the procedures under the headings "Checking Valve Lash" and "Adjusting Valve Lash." 8. For each valve, measure the valve lash with a feeler gauge between the rocker arm and valve bridge. It should be possible to pull the feeler gauge through with no more than light resistance. 9. If the value measured is within the range listed in Table 1-38 in the "Check For" column, check the next valve.

Table 1-38 Valve Lash Checking and Adjustment If the value measured is outside the range given in the "Check For" column listed in Table 1-36, adjust the valve lash. 1.19.3 Valve Lash Adjusting Adjust the valve lash as follows: All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-149 Valve Type Check For: mm (inches) Adjust to: mm (inches) Intake 0.30 to 0.60 (0.012 to 0.024) 0.40 (0.016) Exhaust 0.50 to 0.80 (0.020 to 0.032) 0.60 (0.024)