Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

1.19 VALVES 3. Measure the valve standback listed in Table 1-39, from the cylinder head. See Figure 1-117. NOTE: The valve standback is the difference in height between the lower contact surface of the cylinder head and the valve head, when it is touching the valve seat. 1. Cylinder Head 3. Valve Stem 2. Valve Head Figure 1-117 Measuring Valve Standback Table 1-39 Valve Standback [a] Set the scale of the dial gauge to "0" (zero). [b] Move the dial gauge enough so that its probe is touching the valve head. [c] If the gauge reads between 0.7 and 1.1 mm (0.03 and 0.04 inch), the valve standback is within specifications for new cylinder heads.

Skip down to "Install the cylinder head..."If the gauge reads less than 0.7 mm (0.03 inch), or more than 1.1 mm (0.04 inch), the valve standback is not within specifications. All information subject to change without notice. 1-152 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Valve Type Description mm (inch) Intake Normal 0.7-1.1 (0.03-0.04) Intake Wear Limit 1.6 (0.06) Exhaust Normal 0.7-1.1 (0.03-0.04) Exhaust Wear Limit 1.6 (0.06)