MBE 4000 SERVICE MANUAL [d] For used heads, if the gauge reads more than 1.6 mm (0.06 in.), inspect valve and valve seats.Listed in Table 1-42 are the specifications. 4. Install the cylinder head. Refer to section 1.2.2. 1.19.5 Valve Removal Remove the intake and exhaust valves as follows: NOTE: The MBE 4000 engine has individual heads for each cylinder. To replace the valves on one head, follow these instructions, step by step. To replace all the valves, repeat these instructions for all six cylinder heads. 1. Remove the cylinder head from the engine. Refer to section 1.2.1. 2. Using a dial gauge and holder, measure the valve standback from the cylinder head. Refer to section 1.19.4.
Listed in Table 1-40 are the normal tolerances and wear limits. Table 1-40 Valve Standback NOTE: If the measurement is not within tolerance, machine the valve seat insert, using the procedures . If the measurement is beyond the wear limit, replace the valve seat insert. 3. Place the cylinder head on wooden blocks. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-153 Valve Type Description mm (inch) Intake Normal 0.7-1.1 (0.03-0.04) Intake Wear Limit 1.6 (0.06) Exhaust Normal 0.7-1.1 (0.03-0.04) Exhaust Wear Limit 1.6 (0.06)