Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 9. Inspect the valve guides for wear. See Figure 1-121. Listed in Table 1-41 are the specifications. 1. Valve Guide 2. Cylinder Head Figure 1-121 Measuring the Inside Diameter of the Valve Guide Table 1-41 Inside Diameter of Valve Guide [a] Measure the inside diameter of the valve guide by inserting the go/no go gauge (J 46181 or 636 589 00 21 00) into the valve guide. [b] Replace the valve guide if the larger diameter end of the go/no go gauge tool (J 46181 or 636 589 00 21 00)fits into either end of the guide. 10. Clean the valves thoroughly. Remove any traces of combustion residue. 11. Check the valves to see if they can be re-used.

Replace the valves if the stem ends are damaged or bent, if the valve grooves are deformed, if the seat is burned, or if the chrome surface of the shaft is not entirely intact. 12. Check the following critical valve dimensions, and repair as necessary. See Figure 1-122 to determine the dimensions given in the table. Listed in Table 1-42 are the dimensions. Valve stem diameter (A) All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-157 Description mm (inch) Normal 9.000-9.022 (0.3543-0.3552) Wear Limit 9.050 (0.3563)