Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 14. Inspect the valve springs. Check the springs for correct pressure, using the values listed in Table 1-43. If damaged, replace the springs. Table 1-43 Spring Specifications, Intake and Exhaust Valves 1.19.6 Valve Installation Install the intake and exhaust valves as follows: 1. Lubricate each valve with a light coating of engine oil. 2. Install the valves in order, as marked on removal. NOTE: Always replace the valve stem seal if the valve has been removed. Check the seal to make sure it is correctly seated on the valve guide. Refer to section 1.19.7. 3. Install new valve stem seals. Refer to section 1.19.7. 4.

Using the adaptor/remover, (J 46173), install the spring bases, springs, spring retainers, and collets. Check the collets to be sure they are locked in place. 5. Remove the adaptor/remover, (J 46173), from the cylinder head. 6. Install the cylinder head. Refer to section 1.2.2. 1.19.7 Valve Stem Seal Replacement Replace the valve stem seal as follows: NOTE: Always replace the valve stem seal if the valve has been removed. 1. Remove the cylinder head from the engine. Refer to section 1.2.1. NOTE: Use care during removal to not damage the valve guides and valve stems. All information subject to change without notice.

6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-159 Description mm (inches) Length, Without Load 69.7 (2.74) Length, Under Load of 382-418 N (86-94 lbf) 49 (1.9) Length, Under Load of 644-706 N (145-159 lbf) 37 (1.5) Diameter of Spring Wire 4.2 (0.17) Outside Diameter of Spring Coil 28.9 (1.14) Inside Diameter of Spring Coil 24.5-24.9 (0.96-0.98)