MBE 4000 SERVICE MANUAL 1.20 EGR VALVES The exhaust valves and valve specifications in the EGR engine have changed due to the addition of valve stem sealing rings under the valve stem seals in the engine. 1.20.1 Valve Removal in the EGR Engine Perform the following steps in removing the valves from the EGR engine: 1. Follow the procedures for valve removal in a non-EGR engine until reaching the valve stem seals removal step.Refer to section 1.19.5. 2. With the cylinder head in an upright position, remove and discard the valve stem seals and valve stem sealing rings.See Figure 1-124. 1. Valve Stem Seal 3. Valve Guide 2. Valve Stem Sealing Ring 4.
Cylinder Head Figure 1-124 Removing Valve Stem Seals and Valve Stem Sealing Rings NOTE: The valve guide with valve stem sealing ring are used only in the EGR engines. 3. Check the following critical valve dimensions, and repair as necessary. See Figure 1-125 to determine the dimensions. Listed in Table 1-44 are the dimensions for the intake valve and the differences between the exhaust non-EGR and exhaust EGR valves. Valve stem diameter (A) Valve seat diameter at the contact surface of the cylinder head (B) Valve head diameter (C) All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-161