1.21 ROCKER ARM 1.21 ROCKER ARM Perform the following procedures for removal and installation of the rocker arm: 1.21.1 Rocker Arm Removal Remove the rocker arm assembly as follows: 1. Remove the cylinder head cover on each cylinder head. Refer to section 1.1.1. 2. Remove the rocker arm assembly. See Figure 1-128. 1. Cylinder Head Cover 4. Intake Valve Bridge 2. Rocker Arm Mounting Bolt 5. Exhaust Valve Bridge 3. Rocker Arm Assembly 6. Pushrod Figure 1-128 Rocker Assembly [a] Loosen the each valve lash adjusting screw. [b] Remove each rocker arm mounting bolt. [c] If removing more than one rocker arm assembly, mark the assembly with a paint pen to identify it on installation.
[d] Remove the rocker arm assembly from the cylinder head. 3. Inspect the rocker arm assembly for wear. If necessary, disassemble the rocker arm assembly and replace any worn parts. Refer to section 1.21.2. All information subject to change without notice. 1-166 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION