MBE 4000 SERVICE MANUAL 4. Measure each rocker arm mounting bolt. Replace each bolt longer than 91 mm (3.6 inches), as listed in Table 1-46. Table 1-46 Specifications, Rocker Arm Mounting Bolts 5. Remove the valve bridge from each set of valves, intake and exhaust. 6. Inspect the valve bridges for wear. If necessary, replace any worn valve bridge(s). 1.21.2 Rocker Arm Disassembly Disassemble the rocker arm unit as follows: 1. Remove the rocker arm assembly from the cylinder head. Refer to section 1.21.1. 2. Remove the snap rings from each end of the rocker arm shaft. See Figure 1-129. 1. Snap Ring 5. Intake Rocker Arm 2. Washer 6. Locknut 3. Exhaust Rocker Arm 7. Adjusting Screw 4.
Rocker Support Figure 1-129 Rocker Arm Components All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-167 Size Max. Shaft Length Torque Value M12 91 mm (3.6 in) 60 N·m (44 lb·ft) M12 91 mm (3.6 in) additional 90