MBE 4000 SERVICE MANUAL 3. Inspect each pushrod to be sure it is correctly seated in its tappet. Replace any pushrods that are warped, are not correctly seated, or are not the correct length as listed in Table 1-48. Table 1-48 Rocker Arm Specifications 4. Install the rocker arm assembly. [a] Position the rocker arm assembly on the cylinder head, as removed. [b] Install the mounting bolts in the holes in the cylinder head. [c] Tighten each mounting bolt 60 N·m (44 lb·ft). Final angular tightening: 90 degrees. 5. Adjust the valve lash. 6. Install the cylinder head cover on each cylinder head. Refer to section 1.1.2. All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-169 Description Stage Specification Outside Diameter of Valve Tappets Normal 29.931-29.952 mm (1.1784-1.1792 in) Outside Diameter of Valve Tappets Repair Stage I 30.444-30.465 mm (1.1986-1.1994 in) Diameter of Tappet Seats (in cylinder block) Normal 30.000-30.021 mm (1.1811-1.1819 in) Diameter of Tappet Seats (in cylinder block) Repair Stage I 30.500-30.525 mm (1.2008-1.2018 in) Total Length of Pushrods 345.0-346.5 mm (13.58-13.64 in) Maximum Pushrod Warpage 0.5 mm (0.02 in) Maximum Length of Rocker Arm Mounting Bolts 91 mm (3.6 in)