1.22 CAMSHAFT AND CAMSHAFT SENSOR 1.22 CAMSHAFT AND CAMSHAFT SENSOR The camshaft is made of induction-hardened steel and has seven main bearings. Each cylinder has cams for intake and exhaust valves and a unit pump. 1.22.1 Camshaft Removal Remove the camshaft as follows: NOTE: Before removing the camshaft, clean the engine to prevent road dirt, grease, or other foreign matter from contaminating the exposed gears and other engine parts. 1. Drain the engine oil. PERSONAL INJURY To avoid injury when removing or installing a heavy engine component, ensure the component is properly supported and securely attached to an adequate lifting device to prevent the component from falling.
FALLING ENGINE To avoid injury from a falling engine, ensure the engine is securely attached to the engine overhaul stand before releasing the lifting sling. 2. Remove the engine from the vehicle and support it on a stand. 3. Remove the unit pumps. Refer to section 2.1.1. 4. Remove the vibration damper. Refer to section 1.11.1. 5. Remove the fan support. All information subject to change without notice. 1-170 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION