1.22 CAMSHAFT AND CAMSHAFT SENSOR 1.22.3 Camshaft Sensor Replacement Replace the camshaft sensor as follows: 1. Disconnect the electrical connector. See Figure 1-137. 1. Camshaft Sensor 2. Crank Angle Position Sensor Figure 1-137 Camshaft Sensor Installation 2. Remove the sensor from the access hole in the flywheel housing. 3. Install a new sensor in the flywheel housing. 4. Connect the electrical connector. NOTE: Be sure that the correct electrical connector is connected to the sensor. All information subject to change without notice. 1-180 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION