Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL Cylinder Block The cylinder liner installation tolerances are listed in Table 1-61. The cylinder liner inspection tolerances are listed in Table 1-62. Cylinder Liner measurements are listed in Table 1-63. The specifications for measuring cylinder liner protrusion are listed in Table 1-64. Table 1-61 Cylinder Liner Installation Tolerances Table 1-62 Cylinder Liner Inspection Tolerances Table 1-63 Cylinder Liner Measurements Table 1-64 Specifications for Measuring Cylinder Liner Protrusion All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-187 Description Value:

mm (in.) Cylinder Liner Protrusion, From Block, 1-16, Ref. A. 0.230–0.330 (0.0090–0.0130) Height of the Cylinder Liner Collar, 1-16, Ref. B. 10.10–10.12 (0.3976–0.3984) Depth of the Collar Seat, 1-16, Ref. C. 9.950–10.010 (0.392–0.3941) Thickness of the Seat Insert 0.14–0.16 (0.0055–0.0063) Description Value: mm (in.) Admissible Out-of-Round of the Cylinder Liner, where it contacts the O-rings Max.: 0.02 (0.0007) Admissible Deformation of the Cylinder Liner Collar, at the Contact Surface with the Seat Insert Max.: 0.02 (0.0007) Admissible Deformation of the Liner Collar Seat, at the Contact Surface with the Seat Insert Max.: 0.03 (0.0011) Where To Measure What To Measure Value:

mm (in.) Measuring Point 1: at the O-ring area Inside Diameter of the Cylinder Liner, A class 127.990–127.995 (5.0390–5.0392) Measuring Point 1: at the O-ring area Inside Diameter of the Cylinder Liner, B class 127.995–128.005 (5.0392–5.0396) Measuring Point 1: at the O-ring area Inside Diameter of the Cylinder Liner, C class 128.005–128.010 (5.0396–5.0398) Measuring Point 2: Upper Reversal Point of the First Piston Ring Max. Wear to Cylinder Liner, Measured Along Axis A and Axis B 0.08 (0.003) At Measuring Point 2, Compare Axis A to Axis B Admissible Wear-Out Max.: 0.08 (0.003) Description Value:

mm (in.) Cylinder Liner Protrusion From Block 0.245–0.315 (0.0096–0.0124) Difference Between the Four Measuring Points Max.: 0.02 (0.0007)