Flywheel and Flywheel Housing The flywheel specifications are listed in Table 1-72. The ring gear specifications are listed in Table 1-73. Listed in Table 1-74 are the torque values for the flywheel and the flywheel housing. The tightening stages for the flywheel mounting bolts are listed in Table 1-75. Table 1-72 Flywheel Specifications Table 1-73 Flywheel Ring Gear Specifications Table 1-74 Torque Values for Flywheel and Flywheel Housing All information subject to change without notice.
1-190 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION Description Specification in mm (inches) Flywheel Outside Diameter 486.60-487.40 (19.157-19.189) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 (17.0256-17.0332) Flywheel Diameter at Crankshaft Flange 114.980-115.015 (4.5268-4.5281) Flywheel Diameter for Mounting Clutch 475.000-475.063 (18.7008-18.7032) Flywheel Minimum Width Between Friction Surface and Mounting Flange After Machining 60 (2.4) Flywheel Maximum Overall Width 70 (2.8) Peak-to-Valley Height (R z) of Clutch Friction Surface 0.016 (0.0006) Flywheel Permissible Deviation From True (radial and lateral) 0.2 (0.008) Description Specification, mm (in.) Flywheel Shoulder Diameter (for ring gear mounting) 432.450-432.645 mm (17.0256-17.0332 inches) Hole for Mounting Clutch Pressure Plate M10 x 1.5 Ring Gear Inside Diameter 432.000-432.155 mm (17.0078-17.0139 inches) Ring Gear/Flywheel Interference Fit 0.295-0.645 mm (0.0116-0.0254 inch) Ring Gear/Flywheel Permissible Radial Runout 0.5 mm (0.02 inch) Ring Gear Width 18.4-18.6 mm (0.72-0.73 inch) Ring Gear Fitting Temperature 200-230 C (390-450 F) Item Torque, N·m (lb·ft) Inspection Cover on Flywheel Housing 25 (18) Flywheel Housing Mounting Bolts (to cylinder block) 70 (52) Vibration Damper Mounting Bolts (to crankshaft) 200 (148)