MBE 4000 SERVICE MANUAL Table 1-75 Tightening Stages, Flywheel Mounting Bolts Piston, Piston Ring and Connecting Rod The piston projection specifications are listed in Table 1-76. The piston ring end-gap dimensions are listed in Table 1-77. Listed in Table 1-78 are the pistons inspection specifications. The tightening stages for the connecting rod stretch bolts are listed in Table 1-79. The connecting rod dimensional tolerances are listed in Table 1-80. Listed in Table 1-81 are the connecting rod bearing play specifications. The specifications for the diameter of the bearing bore are listed in Table 1-82. Listed in Table 1-83 are the bearing journal specifications.
The connecting rod bushing specifications are listed in Table 1-84. Table 1-76 Piston Projection Specifications Table 1-77 Piston Ring End-Gap Dimensions Table 1-78 Piston Inspection Specifications All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 1-191 Max.
Shaft Length, mm (in.) Tightening Stage Torque Value, N·m (lb·ft) 77.0 mm (3.03 in) Stage 1 200 N·m (147.5 lb·ft) 77.0 mm (3.03 in) Stage 2 90 degrees Description mm (in.) Piston Projection (from TDC) 0.244 to 0.715 (0.0096 to 0.0281) Ring Designation Groove Gap When New, mm (in.) Maximum End Gap, mm (in.) Keystone I 0.45 to 0.60 (0.018 to 0.024) 1.0 (.039) Taper-Faced with Internal Angle II 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039) Double-Chamfered Oil Control with Garter Spring III 0.40 to 0.55 (0.016 to 0.022) 1.0 (.039) Description Dimensions:
mm (inch) Piston Compression Height 79.50-79.55 (3.130-3.132) Wrist Pin Bore Diameter 52.03-52.04 (2.0484-2.0488) Wrist Pin Diameter 51.992-51.998 (2.0469-2.0472)