2.1 INJECTOR UNIT PUMP PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 7. Connect the fuel line at the fuel gallery inlet. Tighten the fitting 50 N·m (37 lb·ft). 8. Install the fuel lines and pressure limiting valve on the fuel gallery outlet. Tighten all fasteners 50 N·m (37 lb·ft). [a] Install the inner banjo fitting, and two new seal rings, on the pressure limiting valve, as marked on removal. [b] Install the threaded end of the pressure limiting valve in the fuel gallery outlet. When the valve is firmly seated, tighten it 50 N·m (37 lb·ft).
[c] Install the outer banjo fitting, again with two new seal rings, on the banjo bolt, as marked on removal. [d] Install the banjo bolt on the pressure limiting valve and tighten it 50 N·m (37 lb·ft). 9. Install the fuel filter cap. Inspect the O-ring in the fuel filter and replace it if worn. Tighten the cap nut 25 N·m (18 lb·ft). 10. Install the high-pressure fuel injector line. Refer to section 2.3.2. 11. Prime the fuel system. Refer to section 2.9.2. Diesel engine exhaust and some of its constituents are known to the State of California to cause cancer, birth defects, and other reproductive harm. PERSONAL INJURY Always start and operate an engine in a well ventilated area.
If operating an engine in an enclosed area, vent the exhaust to the outside. Do not modify or tamper with the exhaust system or emission control system. 12. Start the engine and check for leaks. Tighten connections as needed. 13. Install the engine trim cover. All information subject to change without notice. 2-10 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION