MBE 4000 SERVICE MANUAL 2.2 EGR INJECTOR UNIT PUMP The removal and installation of the EGR injector unit pump is the same as the non-EGR engine; however, the EGR injector unit pump must be programmed to coordinate with the DDEC-ECU (formerly PLD-MR). 2.2.1 EGR Injector Unit Pump Programming When replacing and before installing a new EPA 04 EGR unit pump, the unit pump identification code number must be programmed into the DDEC-ECU (PLD-MR). Perform the following procedures to insert this code into the unit pump: NOTE: On the top surface of each EGR unit pump, there is a unit pump identification code number.
This is the number that is programmed into the DDEC-ECU (formerly PLD-MR) to coordinate the operation of the unit pumps. See Figure 2-8. 1. Injector Unit Pump 2. Injector Unit Pump Identification Number Figure 2-8 Injector Unit Pump Identification Number 1. Consult the Minidiag2 Manual for service routines. 2. Select routine number 006 – Pump Line Nozzle Change. 3. Enter the unit pump identification Number found on the top of the unit pump. 4. Press enter. 5. Press double-arrow back key. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-11