Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 4. Remove the O-ring from the cylinder head. See Figure 2-16. 1. Nozzle 3. O-ring 2. Protective Sleeve Figure 2-16 Removing the O-ring NOTE: Replace the O-ring whenever the protective sleeve is removed. 2.6.2 Protective Sleeve Installation Install the protective sleeve as follows: 1. Clean the sealing surfaces of the protective sleeve and the cylinder head. 2. Lubricate the new O-ring with a light coating of engine oil. Install the O-ring in the cylinder head. 3. Install the protective sleeve into the cylinder head. Tighten the protective sleeve 45 N·m (33 lb·ft). 4. Install the nozzle. Refer to section 2.4.2. 5. Fill the cooling system with clean coolant.

2.6.3 Crank Angle Position Sensor Replacement Replace the crank angle position sensor as follows: All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-27