MBE 4000 SERVICE MANUAL PERSONAL INJURY To avoid injury from the sudden release of a high-pressure hose connection, wear a face shield or goggles. 3. Disconnect the fuel lines on the heat exchanger. Discard the seal rings. See Figure 2-21. 1. DDEC-ECU Control Unit 5. Seal Ring 2. Fuel Feed Line 6. Fuel Heat Exchanger Mounting Bolt 3. Banjo (Hollow-core) Bolt 7. Fuel Heat Exchanger Inlet 4. Banjo Fitting 8. Fuel Heat Exchanger Figure 2-21 Fuel Heat Exchanger NOTE: Catch any fuel in a clean container. 4. Remove the mounting bolts attaching the fuel heat exchanger to the DDEC-ECU control unit. Then remove the fuel heat exchanger. NOTE: Do not disassemble the fuel heat exchanger.
It cannot be serviced. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-35