Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 2.12 FUEL SYSTEM INSPECTION Perform the following steps to inspect the fuel system for damage: PERSONAL INJURY To avoid injury from penetrating fluids, do not put your hands in front of fluid under pressure. Fluids under pressure can penetrate skin and clothing. FIRE To avoid injury from fire, keep all potential ignition sources away from diesel fuel, including open flames, sparks, and electrical resistance heating elements. Do not smoke when refueling. NOTE: For additional safety precautions, refer to the General Information section of the MBE 4000 Service Manual (6SE412). 1.

Check fuel delivery lines looking for deformation or bent lines, creating restriction and/or obstruction of the flow. 2. Check suction lines and connections looking for damage or under torque, allowing air to enter the fuel system. 3. Check the fuel tank installation. Look for bent/blocked lines, and leaks. 4. Check high-pressure lines for leaks. Look for connector nut leaks at the unit pump and at the transfer tube on the cylinder head. In the event of leaks, disassemble and inspect the high-pressure lines/transfer tube. For proper torque specifications, see those listed in Table 2-2. Table 2-2 Torque Specifications for Fuel Line Nuts 5. Perform a fuel pressure test.

Refer to section 2.12.1. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-47 Component Torque Transfer Tube Nut 45 N·m (33 lb·ft) High Pressure Line Nuts 30 N·m (22 lb·ft)