Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

2.12 FUEL SYSTEM INSPECTION 2.12.2.3 Checking the Fuel Pump Driven Gear Bolt Torque This procedure describes how to check the fuel pump assembly for any play or wear on the fuel pump shaft drive gear mounting bolt. Any play in this component has a big impact on engine performance. 1. Remove the fuel pump. 2. Set the torque wrench to 30 N·m (22 lb·ft). NOTICE: Do not apply a torque over 30 N·m (22 lb·ft). Excessive torque can cause the bolt/gear failure. 3. Turn the torque wrench as shown by the arrow in until the torque wrench “clicks.” This resistance ensures that the fuel pump drive gear is in good condition.

In the event of NO resistance found with shaft turning freely, proceed to the next step. See Figure 2-28. 1. Torque wrench 3. Fuel Pump 2. Fuel Pump Drive Gear Splines Figure 2-28 Checking Fuel Pump Drive Gear 4. Remove the fuel pump drive gear cover. All information subject to change without notice. 2-54 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION