MBE 4000 SERVICE MANUAL Fuel and Fuel Control The fuel control torque values are listed in Table 2-8. Listed in Table 2-9 and listed in Table 2-10 are the fuel system torque values. See Figure 2-30 for a harness drawing of the wiring from the DDEC-ECU (pump and nozzle) control unit. For a detailed (partial) harness drawing showing the interface between the DDEC-ECU and the vehicle control unit (VCU) through the electronic engine frontwall connector, see Figure 2-31. For a detailed (partial) harness drawing showing the DDEC-ECU wiring to the proportioning valves and the oil system sensors, see Figure 2-32.
For a detailed (partial) harness drawing showing the DDEC-ECU wiring to the other system sensors, including charge air, coolant, fuel, crank angle position, and TDC (top dead center), see Figure 2-33. Table 2-8 Fuel Control Torque Values Table 2-9 Fuel System Torque Values Table 2-10 Fuel System Torque Values All information subject to change without notice.
6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 2-59 Fastener Type N·m (lb·ft) Fuel Heat Exchanger Mounting Bolts 8 (6) Fuel Lines 50 (37) DDEC-ECU Control Unit Mounting Bolts 15 (11) Fastener Torque Value, mm (in.) Fuel Filter Cap 25 (18) Fuel Line Banjo Bolts 50 (37) Fuel Line Pipe Fittings 50 (37) High-Pressure Fuel Lines 30 (22) Fuel/Water Separator Mounting Nuts 50 (37) Fuel Filter Housing Mounting Bolts 25 (18) Fuel Pump Mounting Bolts 25 (18) Fastener Torque, mm (in.) Fuel Spill Line Banjo Bolt 15 (11) Fuel Pump Driven Gear Bolt 30 (22) Fuel Temperature Sensor to Engine Block 30 (22)