Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

3.1 OIL PAN 3.1.2 Oil Pan Installation Install the oil pan as follows: 1. Position a new gasket on the cylinder block. 2. Install the pan on the block and tighten each oil pan bolt 35 N·m (26 lb·ft). See Figure 3-4 for the tightening pattern. When all the bolts have been tightened, go back and re-tighten the four corner bolts (positions #1 through #4). Figure 3-4 Oil Pan Bolt Tightening Pattern 3. Install the oil fill tube. Tighten all bolts 25 N·m (18 lb·ft ). [a] Position a new oil fill gasket on the oil pan. [b] Install the oil fill tube bolts. Tighten each bolt 25 N·m (18 lb·ft). [c] Install the fill tube retainer bolt. Tighten the bolt 25 N·m (18 lb·ft).

[d] Replace the O-ring in the oil fill cap. 4. Replace the dipstick seal on the adaptor. Install the adaptor, with the new dipstick seal, on the oil pan. Tighten the nut on the adaptor 50 N·m (37 lb·ft). 5. Install the dipstick guide tube on the adaptor and tighten it 20 N·m (15 lb·ft). 6. Install the dipstick in the dipstick guide tube. Replace the O-ring on the dipstick. 7. Replace the seal on the oil drain plug. Install the oil drain plug, with the new seal, on the oil pan. Tighten the drain plug 80 N·m (59 lb·ft). 8. Install the standoff bracket, as removed. Tighten the locknuts until firm. All information subject to change without notice.

3-6 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION