3.4 OIL PUMP 3.4.2 Oil Pump Disassembly Disassemble the oil pump unit as follows: 1. Remove the oil pump from the cylinder block. Refer to section 3.4.1. 2. Remove the face plate mounting bolts and remove the face plate from the oil pump housing. See Figure 3-13. 1. Face Plate Mounting Bolt 4. Pump Drive Gear 2. Face Plate 5. Pump Housing 3. Idler Gear 6. Drive Wheel Figure 3-13 Oil Pump (exploded view) 3. Remove the idler gear from the pump housing. 4. Using an appropriate drift, press the drive wheel off the pump drive gear. 5. Remove the pump drive gear from the pump housing. 6. Inspect the idler gear, pump drive gear, face plate, and pump housing for damage and excessive wear.
Replace any worn or damaged parts. NOTE: If either the idler gear or pump drive gear needs replacing, replace both gears as a set. All information subject to change without notice. 3-16 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION