Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

MBE 4000 SERVICE MANUAL 7. Check the idler and pump drive gears. Check their seats in the pump housing and face plate. Listed in Table 3-1 are the acceptable limits. Table 3-1 Oil Pump Inspection Limits [a] In the pump housing, measure the diameter of both gear seats, the idler gear seat and the pump drive gear seat. If the measurements are not within acceptable limits, replace the pump housing. [b] Measure the diameter of both shaft seats in the face plate. If the measurements are not within acceptable limits, replace the face plate. [c] Measure the diameter of the pump drive gear shaft and the idler gear shaft.

If the measurements are not within acceptable limits, replace both gears as a set. [d] Using a feeler gauge, measure the clearance between the gears and the pump housing wall. If the measurements are not within acceptable limits, replace both gears as a set. [e] Using a feeler gauge, measure gear backlash (the clearance between two adjacent cogs on different gears). If the measurements are not within acceptable limits, replace both gears as a set. 3.4.3 Oil Pump Assembly Assemble the oil pump unit as follows: BURNS To avoid injury from burning, use lifting tools and heat-resistant gloves when handling heated components. 1.

Heat the drive wheel to approximately 176 F (80 C) in a hot water tank. All information subject to change without notice. 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION 3-17 Description mm (inch) Diameter of Shaft Seat (in pump housing and face plate) 22.000-22.021 (0.8661-0.8670) Diameter of Idler Gear and Pump Drive Gear Shaft 21.93-21.94 (0.8634-0.8638) Clearance of Pump/Idler Gear to Walls of Pump Housing 0.030-0.122 (0.0012-0.0048) Gear Backlash (clearance between gear cogs) 0.312-0.476 (0.0123-0.0187)