Detroit Diesel — Print Preview - C:\Temp\APTCACHE\6SE412A\6SE412A Detroit Diesel

3.7 OIL HEAT EXCHANGER AND FILTER HOUSING 7. Remove the oil heat exchanger (oil radiator) from the heat exchanger housing. Discard the gaskets and save the heat exchanger bolts for later installation. 1. Gasket 3. Heat Exchanger Bolt 2. Heat Exchanger Housing 4. Oil Heat Exchanger Figure 3-21 Heat Exchanger Assembly (typical) 8. Remove the oil pressure/temperature sensor from the heat exchanger/filter housing. 3.7.2 Oil Heat Exchanger and Filter Housing Installation Install the oil heat exchanger and filter housing as follows: 1. Check the oil heat exchanger and the inside of the heat exchanger housing for corrosion, contamination by metal particles, or abrasive material, such as sand.

[a] If corrosion is found, clean or replace the oil heat exchanger, as necessary. [b] Clean the mating surfaces of the oil heat exchanger and heat exchanger housing. Remove any bits of adhering gasket material. 2. Install the oil heat exchanger and new gaskets on the heat exchanger housing. Tighten the heat exchanger bolts 25 N·m (18 lb·ft). All information subject to change without notice. 3-28 6SE412 0403 Copyright © 2004 DETROIT DIESEL CORPORATION